Monitors connected directly to your video card output ports are displayed as 1.1, 1.2, 1.3, etc in ASTER workplaces. Aster does not allow you to assign more than one of these displays to any single workstation if they are assigned to another.
After purchasing a USB-to-HDMI and USB-to-VGA adapter, windows recognizes them as separate video cards in device manager, as such Aster will assign these video outputs as 2, 3, etc in Workplaces (NOTE: These are not video cards with GPU's, just adapters that output video via USB but they use your primary GPU as the graphics processor - see links below)
In order to get multi monitor support for any workstation. You must assign the 1.1, 1.2, 1.3, 1.# to workstation 1 ONLY. Do not assign these to any other workstation.
After this you are free to assign any of the displays labeled as 2,3,4,etc to any other workstation in any combination.
Workstation 1 Displays attached - 1.1, 1.2, 2 (This workstation has 2 monitors attached to directly to the primary video card output,and 1 usb to VGA)
Workstation 2 Displays attached - 2, 3 (This workstation has 2 monitors via 2 USB adapters, usb-to-vga, usb-to-hdmi)
Side Note: video outputs connected directly to your primary video card should be assigned to workstation 1 otherwise you will run into many problems
Hope this helps!
Who is online
Users browsing this forum: No registered users and 1 guest