Ctrl+F12 unresponsive

[Michoko]

Hi again,

On my setup, the CTRL+F12 hotkey is pretty unresponsive, and I often have to press it twice to actually make it work. When you often switch accounts, it can be a bit painful. Do you think it could be possible to make this hotkey detected every time, so we don't have to press CTRL+F12, move the mouse to see if it worked, then press it again if it didn't, until it was properly detected?

Thank you!

My PC:
Windows 10 22H2
I7-12700K
32 GB RAM
RTX 4070

[beast2040]

The first press always moves all input devices to the first position, even if there are no devices in the other places.
Therefore, the first key press looks idle.

[Michoko]

Hmm I see, thank you. So right now, on my setup, it takes two CTRL+F12 presses to switch from Terminal 2 to Terminal 1 (and only one press to switch from Terminal 1 to Terminal 2). Here is the configuration:

Capture d’écran 2023-08-03 150533.jpg (73.37 KiB) Viewed 38350 times

Is it the mandatory behavior, or is there a way to setup Aster so only one press is necessary from switching both ways?

Cheers!